This ad will close in 15 seconds

From : NightFlyyer
Added: Oct 3, 2009
I knocked my DX6i on the floor! Broke 2 switches! I decided, since I have left this TX on more times than not, to put in a "Power ON" light in too. Then I tested it on Blacklight MCX. No strap would help me not drop it, as I knocked it off the bench, when I wasn't even using it. The Power on LED is so I can see from a distance if I left the TX on, not to try to read the screen. I don't need to read my screen after I am done flying. You can't see it when night flying anyway. I opened up the Spektrum DX6i, replaced both switches, and added a 3.5-3.7 Volt LED indicator from Radio Shack. The voltage on the Spektrum is 6v nominal, so any 6 volt LED will work. Any smaller size, then simply put a 100 ohm resister in series with the LED and it will work fine. Make sure to put the LED negative Lead to ANY black wire in the radio. I used the black wire right off the battery pack. Then simply find where the positive turns on and off with the power switch. Find a place that is easy to solder the + lead from the LED to. You can see where I did it in this video on mine. Make sure no wires are interfering with any stick action and put the back back on. This may or may not void any warranties, but was a necessity to me. Hopefully, in the future models, Spektrum will add lights like most other Transmitter Manufacturers have become accustomed to doing. Thanks for watching and Happy "NightFlyying. Dave
Category : Tech

Video Categories:

Also Try: