Recently Featured | Most Discussed | Most Recent | Most Responded | Most Viewed | Top Favorites | Top Rated | TV Serials | Recently Watched
Demonstration of pulling a wheel off rear axle of Walthers 0-8-0, adding washers to limit side-to-side play, pressing wheel back on, and reassembly.
Modified with extra weight, filed drawbar, shims and washers in 4th axle, and filed gearplate. Now pulls 20 cars up a 2% CURVED 18" 4-turn helix grade.
Lots of added weight, plus smoothed drawbar, filed gear cover plate, washers and shims on 4th driving axle, yield an excellent puller.
N-Scale Layout and 2-8-0 with sound
My previous attempts, using the tinytot motors and gearheads, produced good running results, but the various small tinytot motors just could not stand up to hours of continuous ...
I installed a 5-pole Life-Like open-frame motor in the Walthers/Life-Like 0-8-0 to see if it would improve the low-speed running. As best I could, I kept the two engines ...
This slightly modified N Scale loco has extra weight and floating rear bearings, to show that this engine has great pulling capacity with some work. This is on level track....
Just running the engine on its own, this video demonstrates that with a new 5-pole OR with the stock 3-pole motor, this engine will run below 1 scale mph. The trick is to ...
After continued improvements, this is about the slowest/best I can make it run when pulling a train. It does even better on its own (see other video!). I've seen better running ...
The Tiny-Tot 8mmx10mm with 25:1 gearhead is only 15.5mm long total. I put it in this loco for super-slow (and actually TOO slow) speeds). The video says that this is the ...
My first attempt, it turns out, actually was a 25:1 gearhead, not a 5:1. I removed a planetary stage from it and shortened the gearhead housing to convert it to a 5.21:1....
Heres another look at my Unitrack layout. The Kato Dash 9 doesn't exactly match the era of all those steam engines, but I just thought it might be interesting to see them ...
Athearn 2-8-0 Consolidation Baltimore and Ohio N Scale with soundtraxx Tsunami TSU-750 Sound Decoder. The coal load had to be raised a little, but I like the over all turnout ...
This is my Kato N-Scale Layout. It is powered by Digitrax DCC. Kato Unitrack is near perfect track and I was even more impressed with the viaduct sections. All my locomotives ...
A Kato Mikado and a Walthers 0-8-0 yard switcher pull a 14 car train along a 6% grade.
Played by: 0-FIGHT-8 Cover from: Gang Green 0-FIGHT-8 is a newly formed band from Leeuwarden - Holland. This is our first recorded song. Enjoy. Thanks Jaldo for the recording....
easy with tiny or dingo ;)
My title say all XD HAHAHA bye byeeee
1:0 Zuraw (8.) 2:0 N'Diaye (21.) 3:0 Casey (35.) 4:0 Stefulj (39.) 5:0 Krupnikovic (49.) 6:0 Kaufman (68.) www.Atelier-Conny-Fiedler.de
Just another angle of my Kato n scale Unitrack layout.
This is a second video of my Kato n scale Unitrack layout.
Page 1
... Next Page
Related Keywords

Video Categories:
Popular Keywords
Also Try:























